Log subdisks are defined and added to a plex that is to become part of a volume on which dirty region logging (DRL) is enabled. DRL is enabled for a volume when the volume is mirrored and has at least one log subdisk.
See "Dirty region logging" on page 61.
See "Dirty region logging in cluster environments" on page 422.
Log subdisks are ignored as far as the usual plex policies are concerned, and are only used to hold the dirty region log.
See "Preparing a volume for DRL and instant snapshots" on page 285.
To add a log subdisk to an existing plex, use the following command:
vxsd [-g diskgroup
] aslog plex subdisk
where subdisk is the name to be used for the log subdisk. The plex must be associated with a mirrored volume before dirty region logging takes effect.
For example, to associate a subdisk named
mydg02-01 with a plex named
vol01-02, which is already associated with volume
vol01 in the disk group,
mydg, use the following command:
vxsd -g mydg aslog vol01-02 mydg02-01
You can also add a log subdisk to an existing volume with the following command:
vxassist [-g diskgroup
] addlog volume
This command automatically creates a log subdisk within a log plex on the specified disk for the specified volume.