If neither logmap_len nor loglen is specified
| -
loglen is set to a default value that is based on disk group alignment.
-
maplen is set to a reasonable value.
|
If only loglen is specified
| -
For pre-version 110 disk groups,
maplen is set to zero.
-
For version 110 and greater disk groups,
maplen is set to use all the bytes available in the on-disk map.
|
If only logmap_len is specified
| -
For pre-version 110 disk groups,
logmap_len is not applicable.
-
For version 110 and greater disk groups,
maplen must be less than the number of available bytes in the on-disk map for the default log length.
|