Note The Remote Mirror feature requires that the Site Awareness license has been installed on all hosts at all sites that are participating in the configuration.
Use the following command to set the site name for each host:
The name that has been assigned to a site is stored in the /etc/vx/volboot
file, and can be displayed by using the vxdctl
list
command:
To remove the site name from a host, use this command:
The -F
option is required if any imported disk groups are registered to the site.
To tag disks with a site name, use the vxdisk
settag
command as shown here:
# vxdisk
[-g
diskgroup] settag
disk site=
sitename
where the disk can be specified either by the disk access name or the disk media name. You must repeat this command for each of the disks that are to be registered to a site.
To check which disks are registered to a site, use the vxdisk
listtag
command:
# vxdisk
[-g
diskgroup] listtag
To remove the site tag from a disk, use the vxdisk
rmtag
command:
# vxdisk rmtag
disk
site=
sitename