To determine if DRL (configured using a version 20 DCO volume) is enabled on a volume
vxprint
command on the volume to discover the name of its DCO:
Alternatively, you can use this command with the volume:
# vxprint [-g
diskgroup] -F%log_type
volume
This displays the logging type as REGION
for DRL, DRLSEQ
for sequential DRL, or NONE
if DRL is not enabled.
Note If the number of active mirrors in the volume is less than 2, DRL logging is not performed even if DRL is enabled on the volume. To find out if DRL logging is active, see Determining if DRL logging is active on a volume.