You can use the vxprint
-m
command to display the current settings for a volume set. If the makedev
attribute is set to on
, one of the following is displayed in the output:
vset_devinfo=on:read-only
Raw device nodes in read-only mode.
vset_devinfo=on:read-write
Raw device nodes in read-write mode.
This field is not displayed if makedev
is set to off
.
Note
If the output from the vxprint
-m
command is fed to the vxmake
command to recreate a volume set, the vset_devinfo
attribute must set to off
. Use the vxvset set command to re-enable raw device access with the desired access mode as described in Controlling raw device access for an existing volume set.