Enter the cluster information when the installer prompts you.
To configure the cluster
Review the configuration instructions that the installer presents.
Enter the unique cluster name and cluster ID.
Enter the unique cluster name: [q,?] clus1 Enter a unique Cluster ID number between 0-65535: [b,q,?] (0) 7
Review the NICs available on the first system as the installer discovers and reports them.
The private heartbeats can either use NIC or aggregated interfaces. To use aggregated interfaces for private heartbeat, enter the name of the aggregated interface. To use a NIC for private heartbeat, enter a NIC which is not part of an aggregated interface.
Enter the network interface card details for the private heartbeat links.
Is eth1 a bonded NIC? [y,n,q] (n)
You must not enter the network interface card that is used for the public network (typically eth0.)
Enter the NIC for the first private heartbeat link on galaxy: [b,q,?] eth1 eth1 has an IP address configured on it. It could be a public NIC on galaxy. Are you sure you want to use eth1 for the first private heartbeat link? [y,n,q,b,?] (n) y Is eth1 a bonded NIC? [y,n,q] (n) Would you like to configure a second private heartbeat link? [y,n,q,b,?] (y) Enter the NIC for the second private heartbeat link on galaxy: [b,q,?] eth2 eth2 has an IP address configured on it. It could be a public NIC on galaxy. Are you sure you want to use eth2 for the first private heartbeat link? [y,n,q,b,?] (n) y Is eth2 a bonded NIC? [y,n,q] (n) Would you like to configure a third private heartbeat link? [y,n,q,b,?](n) Do you want to configure an additional low priority heartbeat link? [y,n,q,b,?] (n)
Choose whether to use the same NIC details to configure private heartbeat links on other systems.
Are you using the same NICs for private heartbeat links on all systems? [y,n,q,b,?] (y)
If you want to use the NIC details that you entered for galaxy, make sure the same NICs are available on each system. Then, enter y at the prompt.
If the NIC device names are different on some of the systems, enter n. Provide the NIC details for each system as the program prompts.
Verify and confirm the information that the installer summarizes.