Veritas File System (VxFS) supports non-global zone root on a VxFS clustered file system. Symantec provides the following steps to make each system in a cluster aware of a non-global zone that resides on a VxFS clustered file system:
To create a non-global zone root on a VxFS clustered file system configuration
On the first system, configure, install, boot, halt the non-global zone and remove its zone root.
Ensure that the non-global zone is in the installed state:
# zoneadm list -cv ID NAME STATUS PATH BRAND IP 0 global running / native shared - zonename installed /zonepath/zonename native shared
If the non-global zone is not in the installed state, then you might have not configured the non-global zone correctly. Refer to Sun Microsystems' documentation.
Repeat steps Step 1 and Step 2 for each system in the cluster, except the last system.
On the last system in the cluster, configure, install, and boot the non-global zone.
Configure the non-global zone:
# zonecfg -z zonename
Refer to Sun Microsystems' documentation for more information.
# zoneadm -z zonename install
# zoneadm -z zonename boot
On the systems that were halted in step Step 1, boot the non-global zone:
# zoneadm -z zonename boot