Removing the error state for simple or nopriv disks in the boot disk group
If the boot disk group (usually aliased as bootdg) is comprised of only simple and/or nopriv disks, the vxconfigd daemon goes into the disabled state after the naming scheme change.
To remove the error state for simple or nopriv disks in the boot disk group
-
Use vxdiskadm to change back to c#t#d#s# naming.
-
Enter the following command to restart the VxVM configuration daemon:
# vxconfigd -kr reset
-
If you want to use enclosure-based naming, use vxdiskadm to add a sliced disk to the bootdg disk group, change back to the enclosure-based naming scheme, and then run the following command:
# vxdarestore