ACTIVE
|
The volume has been started (the kernel state is currently ENABLED) or was in use (the kernel state was ENABLED) when the machine was rebooted.
If the volume is ENABLED, the state of its plexes at any moment is not certain (because the volume is in use). If the volume is DISABLED, the plexes cannot be guaranteed to be consistent, but are made consistent when the volume is started.
For a RAID-5 volume, if the volume is DISABLED, parity cannot be guaranteed to be synchronized.
|
CLEAN
|
The volume is not started (the kernel state is DISABLED) and its plexes are synchronized. For a RAID-5 volume, its plex stripes are consistent and its parity is good.
|
EMPTY
|
The volume contents are not initialized. When the volume is EMPTY, the kernel state is always DISABLED.
|
INVALID
|
The contents of an instant snapshot volume no longer represent a true point-in-time image of the original volume.
|
NEEDSYNC
|
You must resynchronize the volume the next time it is started. A RAID-5 volume requires a parity resynchronization.
|
REPLAY
|
The volume is in a transient state as part of a log replay. A log replay occurs when it becomes necessary to use logged parity and data. This state is only applied to RAID-5 volumes.
|
SYNC
|
The volume is either in read-writeback recovery mode (the kernel state is ENABLED) or was in read-writeback mode when the machine was rebooted (the kernel state is DISABLED). With read-writeback recovery, plex consistency is recovered by reading data from blocks of one plex and writing the data to all other writable plexes. If the volume is ENABLED, the plexes are being resynchronized through the read-writeback recovery. If the volume is DISABLED, the plexes were being resynchronized through read-writeback when the machine rebooted and still need to be synchronized.
For a RAID-5 volume, the volume is either undergoing a parity resynchronization (the kernel state is ENABLED) or was having its parity resynchronized when the machine was rebooted (the kernel state is DISABLED).
|