Starting the software configuration
Prev Configuring SFCFSHA Next

Starting the software configuration

You can configure SFCFSHA using the Veritas product installer or the installsfcfsha command.

Note:

If you want to reconfigure SFCFSHA, before you start the installer you must stop all the resources that are under VCS control using the hastop command or the hagrp -offline command.

To configure SFCFSHA using the product installer

  1. Confirm that you are logged in as the superuser and that you have mounted the product disc.
  2. Start the installer.
    # ./installer

    The installer starts the product installation program with a copyright message and specifies the directory where the logs are created.

  3. From the opening Selection Menu, choose: C for "Configure an Installed Product."
  4. From the displayed list of products to configure, choose the corresponding number for your product:

    Storage Foundation Cluster File System High Availability

To configure SFCFSHA using the installsfcfsha program

  1. Confirm that you are logged in as the superuser.
  2. Start the installsfcfsha program, with the configure option.
    # /opt/VRTS/install/installsfcfsha<version> -configure

    Where <version> is the specific release version.

    See About the Veritas installer.

    The installer begins with a copyright message and specifies the directory where the logs are created.

Prev Up Next
Overview of tasks to configure SFCFSHA using the script-based installer Home Specifying systems for configuration