You can choose to configure VCS to send event notifications to SNMP management consoles. You need to provide the SNMP management console name to be notified and message severity levels.
Note that you can also configure the notification after installation.
Refer to the Veritas Cluster Server Administrator's Guide for more information.
To configure the SNMP trap notification
Do you want to configure SNMP notification? [y,n,q,?] (n) y
If you skip this option and if you had installed a valid HA/DR license, the installer presents you with an option to configure this cluster as global cluster. If you did not install an HA/DR license, the installer proceeds to configure SFCFSHA based on the configuration details you provided.
Provide the following information:
Enter the NIC information.
Active NIC devices discovered on sys1: bge0 Enter the NIC for the VCS Notifier to use on sys1: [b,q,?] (bge0) Is bge0 to be the public NIC used by all systems? [y,n,q,b,?] (y)
Enter the SNMP trap daemon port.
Enter the SNMP trap daemon port: [b,q,?] (162)
Enter the SNMP console system name.
Enter the SNMP console system name: [b,q,?] sys5
Enter the minimum security level of messages to be sent to each console.
Enter the minimum severity of events for which SNMP traps should be sent to sys5 [I=Information, W=Warning, E=Error, S=SevereError]: [b,q,?] E
Add more SNMP consoles, if necessary.
If you want to add another SNMP console, enter y and provide the required information at the prompt.
Would you like to add another SNMP console? [y,n,q,b] (n) y Enter the SNMP console system name: [b,q,?] sys4 Enter the minimum severity of events for which SNMP traps should be sent to sys4 [I=Information, W=Warning, E=Error, S=SevereError]: [b,q,?] S
If you do not want to add, answer n.
Would you like to add another SNMP console? [y,n,q,b] (n)
NIC: bge0
SNMP Port: 162 Console: sys5 receives SNMP traps for Error or higher events Console: sys4 receives SNMP traps for SevereError or higher events Is this information correct? [y,n,q] (y)