If you had installed a valid HA/DR license, the installer provides you an option to configure this cluster as global cluster.
You can configure global clusters to link clusters at separate locations and enable wide-area failover and disaster recovery. The installer adds basic global cluster information to the VCS configuration file. You must perform additional configuration tasks to set up a global cluster.
See the Veritas Storage Foundation Cluster File System High Availability Installation Guide for instructions to set up SFCFSHA global clusters.
Note: |
If you installed a HA/DR license to set up replicated data cluster or campus cluster, skip this installer option. |
To configure the global cluster option
Do you want to configure the Global Cluster Option? [y,n,q] (n) y
If you skip this option, the installer proceeds to configure VCS based on the configuration details you provided.
The installer prompts you for a NIC, a virtual IP address, and value for the netmask.
If you had entered virtual IP address details, the installer discovers the values you entered. You can use the same virtual IP address for global cluster configuration or enter different values.
You can also enter an IPv6 address as a virtual IP address.