Completing the SFCFSHA configuration

After you enter the SFCFSHA configuration information, the installer prompts to stop the SFCFSHA processes to complete the configuration process. The installer continues to create configuration files and copies them to each system. The installer also configures a cluster UUID value for the cluster at the end of the configuration. After the installer successfully configures SFCFSHA, it restarts SFCFSHA and its related processes.

To complete the SFCFSHA configuration

  1. If prompted, press Enter at the following prompt.
    Do you want to stop SFCFSHA processes now? [y,n,q,?] (y)
  2. Review the output as the installer stops various processes and performs the configuration. The installer then restarts SFCFSHA and its related processes.
  3. Enter y at the prompt to send the installation information to Symantec.
    Would you like to send the information about this installation
    to Symantec to help improve installation in the future? 
    [y,n,q,?] (y) y
  4. After the installer configures SFCFSHA successfully, note the location of summary, log, and response files that installer creates.

    The files provide the useful information that can assist you with the configuration and can also assist future configurations.

    summary file

    Describes the cluster and its configured resources.

    log file

    Details the entire configuration.

    response file

    Contains the configuration information that can be used to perform secure or unattended installations on other systems.

    See Configuring SFCFSHA using response files.