This section describes the procedures to configure server-based fencing on a new node. Depending on whether server-based fencing is configured in secure or non-secure mode on the existing cluster, perform the tasks in one of the following procedures:
Server-based fencing in non-secure mode:
To configure server-based fencing in non-secure mode on the new node
Server-based fencing in secure mode:
To configure server-based fencing with security on the new node
To configure server-based fencing in non-secure mode on the new node
# cpsadm -s cps1.symantecexample.com \ -a add_node -c clus1 -h sys5 -n2 Node 2 (sys5) successfully added
# cpsadm -s cps1.symantecexample.com \ -a list_nodes
The new node must be listed in the command output.
# cpsadm -s cps1.symantecexample.com \ -a add_user -e cpsclient@sys5 \ -f cps_operator -g vx User cpsclient@sys5 successfully added
To configure server-based fencing with security on the new node
# cpsadm -s cps1.symantecexample.com \ -a add_node -c clus1 -h sys5 -n2 Node 2 (sys5) successfully added
# cpsadm -s cps1.symantecexample.com -a list_nodes
The new node must be listed in the output.