Figure: A typical configuration of links crossing an IP router depicts a typical configuration of links crossing an IP router employing LLT over UDP. The illustration shows two nodes of a four-node cluster.
The configuration that the following /etc/llttab file represents for Node 1 has links crossing IP routers. Notice that IP addresses are shown for each link on each peer node. In this configuration broadcasts are disabled. Hence, the broadcast address does not need to be set in the link command of the /etc/llttab file.
set-node Node1 set-cluster 1 link link1 /dev/xti/udp - udp 50000 - 192.1.3.1 - link link2 /dev/xti/udp - udp 50001 - 192.1.4.1 - #set address of each link for all peer nodes in the cluster #format: set-addr node-id link tag-name address set-addr 0 link1 192.1.1.1 set-addr 0 link2 192.1.2.1 set-addr 2 link1 192.1.5.2 set-addr 2 link2 192.1.6.2 set-addr 3 link1 192.1.7.3 set-addr 3 link2 192.1.8.3 #disable LLT broadcasts set-bcasthb 0 set-arp 0
The /etc/llttab file on Node 0 resembles:
set-node Node0 set-cluster 1 link link1 /dev/xti/udp - udp 50000 - 192.1.1.1 - link link2 /dev/xti/udp - udp 50001 - 192.1.2.1 - #set address of each link for all peer nodes in the cluster #format: set-addr node-id link tag-name address set-addr 1 link1 192.1.3.1 set-addr 1 link2 192.1.4.1 set-addr 2 link1 192.1.5.2 set-addr 2 link2 192.1.6.2 set-addr 3 link1 192.1.7.3 set-addr 3 link2 192.1.8.3 #disable LLT broadcasts set-bcasthb 0 set-arp 0