Installing and configuring VCS at the secondary site
Prev Configuring clusters for global cluster setup Next

Installing and configuring VCS at the secondary site

Perform the following steps to set up a VCS cluster at the secondary site.

To install and configure VCS at the secondary site

  1. At the secondary site, install and configure VCS cluster.

    Note the following points for this task:

    • During VCS installation, enable licenses for global clusters.

    • During VCS configuration, answer the prompts to configure global cluster. This step configures the virtual IP for inter-cluster communication.

    See the Veritas Cluster Server Installation Guide for instructions.

  2. Verify that the gcoip resource that monitors the virtual IP address for inter-cluster communication is online.
    hares -state gcoip
Prev Up Next
Configuring global cluster components at the primary site Home Securing communication between the wide-area connectors