Setting up the node to run in secure mode
Prev Adding the node to a cluster manually Next

Setting up the node to run in secure mode

You must follow this procedure only if you are adding a node to a cluster that is running in secure mode. If you are adding a node to a cluster that is not running in a secure mode, proceed with configuring LLT and GAB.

Table: The command examples definitions uses the following information for the following command examples.

Table: The command examples definitions

Name

Fully-qualified host name (FQHN)

Function

saturn

saturn.nodes.example.com

The new node that you are adding to the cluster.
Prev Up Next
Configuring cluster files on the new node Home Configuring the authentication broker on node saturn