Analyzing the collected data
This section describes how to analyze the collected data.
To analyze the collected data using VRAdvisor
- Launch the VRAdvisor wizard.
- In the Welcome page, select , and then click .
- In the Directory Specification page, specify the directory, and then click .
- In the File Selection page, select the files to be analyzed, and then click .
- In the Block Size and Collection Interval Specification page, specify the metadata, and then click .
- In the Volume or Disk Selection page, select the volumes or disks to be analyzed, and then click .
- The RVG Summary page displays the disks or volumes that were selected for analysis. The disks or volumes for each analyzed file are grouped under an RVG name.
Click to modify the selections, or click to continue.
- In the Network Parameters for Analysis page, specify the parameters that apply to all defined RVGs, and then click .
- Complete the RVG Specific Parameters page, and then click .
- In the Summary of Inputs page, click to modify the parameters, or select to start the analysis.
VRAdvisor displays the results of the analysis for the selected data files.