Adding the node to the existing cluster
Perform the tasks on one of the existing nodes in the cluster.
To add the new node to the existing cluster
-
Enter the command:
# haconf -makerw
-
Add the new system to the cluster:
# hasys -add
east
-
Stop VCS on the new node:
# hastop -sys east
-
Copy the main.cf file from an existing node to your new node:
# rcp /etc/VRTSvcs/conf/config/main.cf east:/etc/VRTSvcs/conf/config/
-
Start VCS on the new node:
# hastart
-
If necessary, modify any new system attributes.
-
Enter the command:
# haconf -dump -makero