< Previous  | TOC | Index | Next  >

Configuring VCS 5.0

You can proceed to configure VCS now or allow to install the VCS depots and then configure VCS at a later time.

It is optional to configure VCS now. If you choose to configure 
VCS later, you can either do so manually or run the 
installvcs -configure command. 
 
 


 Are you ready to configure VCS? [y,n,q] (y) y


 


 To configure VCS, please answer the following sets of questions.


 


When a [b] is presented after a question, 'b' may be entered to 
go back to the first question of the configuration set.
 
 


When a [?] is presented after a question, '?' may be entered for 
help or additional information about the question.
 
 


Following each set of questions, the information you have 
entered will be presented for confirmation. To repeat the set of 
questions and correct any previous errors, enter 'n' at the 
confirmation prompt.
 
 


No configuration changes are made to the systems until all 
configuration questions are completed and VCS is installed 
successfully.
 
 

Perform the following tasks as the installer takes you through different screens:

• Configure the cluster
• Configure the cluster in secure mode
• Add VCS users
• Configure Cluster Management Console
• Configure cluster connector
• Configure SMTP email notification
• Configure SNMP trap notification
• Configure the global cluster option
• Installer installs the VCS depots
• Installer creates VCS configuration files
• Start VCS
• Complete the installation