< Previous  | TOC | Index | Next  >

Verify the status of nodes and service groups

Start by issuing the following commands from one of the nodes to remain, node A or node B.

 To verify the status of the nodes and the service groups

1. Make a backup copy of the current configuration file, main.cf.

   # cp -p /etc/VRTSvcs/conf/config/main.cf \

   /etc/VRTSvcs/conf/config/main.cf.goodcopy

2. Check the status of the systems and the service groups.

   # hastatus -summary

   -- SYSTEM STATE

   -- System State Frozen

   A A RUNNING 0

   A B RUNNING 0

   A C RUNNING 0

   -- GROUP STATE

   -- Group System Probed AutoDisabled State

   B grp1 A Y N ONLINE

   B grp1 B Y N OFFLINE

   B grp2 A Y N ONLINE

   B grp3 B Y N OFFLINE

   B grp3 C Y N ONLINE

   B grp4 C Y N ONLINE

   The example output from the hastatus command shows that nodes A, B, and C are the nodes in the cluster. Also, service group grp3 is configured to run on node B and node C, the leaving node. Service group grp4 runs only on node C. Service groups grp1 and grp2 do not run on node C.