Perform the following tasks on each of the remaining nodes of the cluster.
To modify the configuration files on a remaining node
No change is required to this file if the /sbin/gabconfig
command has only the argument -c
, although Symantec recommends using the -n
N
option, where N is the number of cluster systems.
If the command has the form /sbin/gabconfig -c -n
N
, where N is the number of cluster systems, then make sure that N is not greater than the actual number of nodes in the cluster, or GAB does not automatically seed.
Note
Symantec does not recommend the use of the -c -x
option for /sbin/gabconfig
. The Gigabit Ethernet controller does not support the use of -c -x
.