< Previous  | TOC | Index | Next  >

Adding VCS users

If you have enabled Symantec Product Authentication Service, you do not need to add VCS users now.

Proceed to configure the Cluster Management Console cluster connector. Otherwise, on systems operating under an English locale, you can add VCS users at this time.

See Configuring the cluster in secure mode.

See Configuring cluster connector.

 To add VCS users

1. Review the required information to add VCS users.
2. Reset the password for the Admin user, if necessary.

   Do you want to set the password for the Admin user

   (default password='password')? [y,n,q] (n) y

   Enter New Password:******

   Enter Again:******

3. To add a user, enter y at the prompt.

   Do you want to add another user to the cluster? [y,n,q] (y)

4. Enter the user's name, password, and level of privileges.

   Enter the user name: [?] smith

   Enter New Password:*******

   Enter Again:*******

Enter the privilege for user smith (A=Administrator, O=Operator, 
G=Guest): [?] a
 

5. Enter n at the prompt if you have finished adding users.

   Would you like to add another user? [y,n,q] (n)

6. Review the summary of the newly added users and confirm the information.