Configuring the Cluster Management Console
If you want to locally manage this cluster, then you must configure the Cluster Management Console. Note that this cluster can also be a part of the clusters that are centrally managed by the management server.
See Veritas Cluster Management Console
To configure the Cluster Management Console
-
Review the required information to configure the Cluster Management Console.
-
Choose whether to configure the Cluster Management Console or not. Do one of the following:
-
Confirm whether you want to use the discovered public NIC on the first system. Do one of the following:
-
Confirm whether you want to use the same public NIC on all nodes. Do one of the following:
-
If all nodes use the same public NIC, enter
y
.
-
If unique NICs are used, enter
n
and enter a NIC for each node.
Is lan0 to be the public NIC used by all systems [y,n,q,b,?] (y)
-
Enter the virtual IP address for the Cluster Management Console.
Enter the Virtual IP address for Cluster Management Console:
[b,?] 10.10.12.1
-
Confirm the default netmask or enter another one:
Enter the netmask for IP 10.10.12.1: [b,?] (255.255.240.0)
-
Enter the NetworkHosts IP addresses, separated by spaces, for checking the connections.
Enter the NetworkHosts IP addresses, separated by spaces: [b,?]
10.10.12.2
-
Verify and confirm the Cluster Management Console information.
Cluster Management Console verification:
NIC: lan0
IP: 10.10.12.1
Netmask: 255.255.240.0
NetworkHosts: 10.10.12.2
Is this information correct? [y,n,q] (y)