< Previous  | TOC | Index | Next  >

Unloading LLT and GAB and removing VCS on the leaving node

Perform the tasks on the node leaving the cluster.

 To stop LLT and GAB and remove VCS

1. Stop GAB and LLT:

   # /etc/init.d/gab stop

   # /etc/init.d/llt stop

2. To determine the RPMs to remove, enter:

   # rpm -qa | grep VRTS

3. To permanently remove the VCS RPMs from the system, use the rpm -e command. Start by removing the following RPMs, which may have been optionally installed, in the order shown:

   # rpm -e VRTScscm

   # rpm -e VRTSvcsw

   # rpm -e VRTScscw

   # rpm -e VRTScssim

   # rpm -e VRTScutil

   # rpm -e VRTSvcsdc

   # rpm -e VRTSvcsmn

   # rpm -e VRTSvcsag

   # rpm -e VRTSvcsmg

   # rpm -e VRTSvcs

   # rpm -e VRTSvxfen

   # rpm -e VRTSgab

   # rpm -e VRTSllt

   # rpm -e VRTSperl

4. Optionally, you can remove the infrastructure RPMs in the order shown:

   # rpm -e VRTSvlic

   # rpm -e VRTScpi

   # rpm -e VRTSperl

   # rpm -e VRTSweb

   # rpm -e VRTSjre

5. Remove the LLT and GAB configuration files.

   # rm /etc/llttab

   # rm /etc/gabtab

   # rm /etc/llthosts