Creating a single-node cluster manually
Prev Installing VCS on a single node Next

Creating a single-node cluster manually

Table: Tasks to create a single-node cluster manually specifies the tasks that you need to perform to install VCS on a single node.

Table: Tasks to create a single-node cluster manually

Task

Reference

Set the PATH variable

See Setting the path variable for a manual single node installation.

Install the VCS software manually and add a license key

See Installing the VCS software manually on a single node.

Remove any LLT or GAB configuration files and rename LLT and GAB startup files.

A single-node cluster does not require the node-to-node communication service, LLT, or the membership communication service, GAB.

See Renaming the LLT and GAB startup files.

Create and modify the VCS configuration files.

See Configuring VCS.

Start VCS and verify single-node operation.

See Verifying single-node operation.
Prev Up Next
Starting the installer for the single node cluster Home Setting the path variable for a manual single node installation