After removing a node from a VCS cluster, perform the steps in the following procedure to remove that node's configuration from the CP server.
Note: |
The cpsadm command is used to perform the steps in this procedure. For detailed information about the cpsadm command, see the Cluster Server Administrator's Guide. |
To remove the node configuration from the CP server
If the CP server is configured to use HTTPS-based communication, run the following command:
# cpsadm -s cp_server -a list_users
Where cp_server is the virtual IP/ virtual hostname of the CP server.
# cpsadm -s cp_server -a rm_node -h sys5 -c clus1 -n 2
# cpsadm -s cp_server -a list_nodes