 | ||
| Managing a plan | ||
|---|---|---|
| Prev | Appendix A. Using Veritas AppProtect for vSphere | Next |
After the maintenance plan is created, you can fail over the applications to the clone virtual machine and fail back the applications from the clone to the virtual machine. When the scheduled maintenance is complete, you can delete the cloned virtual machine or retain it for future use.
To perform failover, failback, revert, or delete clone operations, go to Plans, and select a plan. Based on the enabled operation, perform the following tasks:
To fail over the applications to the cloned virtual machine
Just In Time Availability (JIT) performs the sequence of failover tasks, which includes taking the application offline, detaching the disks, cloning the virtual machine, attaching the disks, and so on.
To fail back the applications from the clone to the primary virtual machine
Just In Time Availability (JIT) performs the sequence of failback tasks, which includes taking the application offline, detaching the disks, attaching the disks, and so on.
To revert a failover or a failback operation
If the failover or a failback operation fails, the revert operation restores the applications on the virtual machine, and deletes the clone if created.
To delete a clone
After the failback operation is complete, you can delete the clone. By default, the revert operation deletes the clone.
Note: |
Alternatively, right-click in the Plans table on the Plans wizard to perform failover, failback, revert, delete plan, and delete clone operations. |
Once you have set up a plan for unplanned recovery during Configure Plan operation, based on the recovery policies selected for the plan, the application is recovered accordingly.
You can manage unplanned recovery policies settings by performing the following operations on the plan and its associated virtual machines.
On the Plans tab, in the plans table which lists all the existing plans, navigate to the required plan and use the right-click option on the selected plan.
Edit: Use this option to modify the configured plans settings such as adding or removing a virtual machine from the plan, and so on.
The same Configuration Plan wizard using which you had set up or configured a plan is displayed with pre-populated details.
See Setting up a plan.
Disable Unplanned Recovery: Use this option to disable the Unplanned Recovery settings.
Enable Unplanned Recovery: Use this option to enable the Unplanned Recovery settings.
Disable Scheduler: Use this option to disable the scheduler settings.
Enable Scheduler: Use this option to enable the scheduler settings.
Delete Plan: Use this option to delete the created plan.
Properties: Use this option to view the properties for unplanned recovery. It displays details such as the selected unplanned recovery policies and the associated operations for the selected policies. It also provides information about the selected scheduler mode for performing boot disk back up operation for the selected virtual machines.
On the Plans tab, in the plans table which lists all the existing plans and its associated virtual machines, navigate to the required virtual machine. Select the required virtual machine and use the right-click option on the selected virtual machine.
Remove VM From Plan: Use this option to delete the virtual machine from the selected plan.
Create Clone Backup: Use this option to create a boot disk backup copy of the virtual machine.
Unplanned Failback: Use this option to fail back the application from the boot disk backup copy of the virtual machine on target ESX to the original virtual machine on primary ESX.
Properties: Use this option to view properties such as the last run time for backup operation, last successful backup attempt time and the target ESX details.
See Plan states.