 | ||
| Configuring deep discovery for EMC CLARiiON storage enclosures | ||
|---|---|---|
| Prev | Performing the deep discovery of enclosures | Next |
| ||
| Configuring deep discovery for EMC CLARiiON storage enclosures | ||
|---|---|---|
| Prev | Performing the deep discovery of enclosures | Next |
The Veritas Operations Manager Storage Insight Add-on for Deep Array Discovery and Mapping provides you detailed information on the storage enclosures in your datacenter. By bringing you the information to the level of adapters and disks, the Storage Insight Add-on lets you understand your storage enclosures in a much deeper level.
As part of its deep array discovery capabilities, the Storage Insight Add-on provides you options to understand the EMC CLARiiON enclosures in your datacenter in a better way. Storage Insight Add-on communicates to the EMC CLARiiON enclosures through the NaviSphere Secure CLI (NaviSecCLI) utility, which is the secure CLI for communicating to the NaviSphere package on the enclosure. The NaviSphere Secure CLI utility must be installed on a control host that is a part of the Veritas Operations Manager domain.
After you configure deep discovery, you can view the following information on the details page of an EMC CLARiiON enclosure:
Storage Insight Add-on supports only the EMC CLARiiON CX series enclosures with a firmware version 6.26 and later.
Note: |
Storage Insight Add-on supports only the NaviSphere Secure CLI, version 6.29. It does not support the NaviSphere Classic CLI (NaviCLI). |
To Configure deep discovery for the EMC CLARiiON enclosures
In the Veritas Operations Manager console, select Settings > Enclosure Management.
In the Enclosure Management page, click Configure New Device.
In the Configure Device wizard panel to specify the details of the devices, enter the required information. Click Next.
See Configure Device panel for deep discovery of enclosures.
In the Configure Device wizard panel that lists the EMC CLARiiON enclosures, enter the required information to update discovery information. Click Finish.
See Configure Device panel to update the deep discovery information for enclosures.