You can perform a reattach operation if a disk could not be found at system startup, or if VxVM is started with some disk drivers unloaded and unloadable (causing disks to enter the failed
state). If the underlying problem has been fixed (such as a cable or controller fault), use the vxreattach
command to reattach the disks without plexes being flagged as STALE. However, the reattach must occur before any volumes on the disk are started.
The vxreattach
command is called as part of disk recovery from the vxdiskadm
menus and during the boot process. If possible, vxreattach
reattaches the failed disk media record to the disk with the same device name. Reattachment places a disk in the same disk group that it was located in before and retains its original disk media name.
vxdisk
list
command to see which disks have failed, as shown in the following example:
sdp auto:sliced mydg01 mydg online
sdq auto:sliced mydg02 mydg online
vxreattach
command with no options to reattach the disks:
After reattachment takes place, recovery may not be necessary unless a disk was faulty and had to be replaced. Reattachment can fail if the original (or another) cause for the disk failure still exists.
You can use the command vxreattach
-c
to check whether reattachment is possible, without performing the operation. Instead, it displays the disk group and disk media name where the disk can be reattached.