< Previous  | TOC | Index | Next  >

Configuring cluster connector

If you configured the Cluster Management Console management server to centrally manage this cluster, you can now configure cluster connector for the buffering feature. If a firewall exists between the management server and this cluster, then you must configure cluster connector to enable centralized management. Make sure you meet the prerequisites to configure cluster connector.

See Veritas Cluster Management Console.

 To configure cluster connector

1. Review the information to configure Cluster Management Console.
2. Choose whether to configure cluster connector or not. Do one of the following:
   • To configure cluster connector on the systems, press Enter.

     Do you want this cluster to be managed by a management

     server? Enter 'y' if you have set up a management server.

     [y,n,q] (y) y

   • To skip configuring cluster connector and advance to configuring Cluster Management Console for local cluster management, enter n.

     See Configuring the Cluster Management Console

3. Review the required information to configure cluster connector.
4. Enter the Management Server network address for Cluster Management Console.

   Enter the network address used by the management server [?] (north) mgmtserver1.symantecexample.com

5. Verify and confirm the management server information.
6. Enter the following information that is required to securely communicate with the management server.
   • Password for the service account that is created during the management service installation
   • Hash of Cluster Management Console management server's root broker
7. Verify and confirm the information.