Scanning an operating system device tree after adding or removing LUNs
Prev Dynamic reconfiguration of devices Next

Scanning an operating system device tree after adding or removing LUNs

After you add or remove LUNs, scan the operating system device tree to verify that the operation completed successfully.

The operating system commands may vary, depending on the Solaris version. The following procedure uses Solaris 10 with the Leadville stack.

To scan an operating system device tree after adding or removing LUNs

  1. Enter the following command:
    # cfgadm -c configure c2

    where c2 is the controller ID 2.

  2. Enter the following command:
    # devfsadm -Cv
Prev Up Next
About detecting target ID reuse if the operating system device tree is not cleaned up Home Cleaning up the operating system device tree after removing LUNs