You must perform this upgrade on each cluster that formerly used CommandCentral Availability cluster monitor to communicate with the CommandCentral Availability management server. This procedure follows a script of a successful upgrade. If at any step you experience a result other than the expected result that is documented here, you can click "n" to re-enter information. If you continue to have problems, click "q" to quit the installation and then verify the installation prerequisites.
To upgrade cluster monitor to cluster connector
The setup program presents copyright information followed by a menu titled, "Storage Foundation and High Availability Solutions 5.0".
i
to specify a task.
Enter a Task: [I,C,L,P,U,D,Q,?] i
The setup program displays another menu that lists products that are available for installation.
2
to select a product component.
Enter '1' to install the management server, '2' to install the clusterThe setup program presents a message stating that it will install cluster connector.
y
to verify that the information up to this point is correct.
Is this information correct? [y,n,q] (y)
The setup program performs an initial system check of the local system and checks for installed packages on the local system. If these checks are satisfactory, the setup program lists the packages to be installed.
installer will upgrade or install the following Cluster Management ConsoleVRTSat Symantec Product Authentication Service
VRTSperl Veritas Perl 5.8.8 Redistribution
VRTScmccc Veritas Cluster Management Console Cluster Connector
The setup program displays the following message:
Installer is now ready to upgrade Cluster Management Console.
All Cluster Management Console processes that are currently running must be stopped.
Are you sure you want to upgrade Cluster Management Console? [y,n,q] (y)
The password is the password that was entered for the cluster connector service account during management server installation.
Enter the hash of the Management Server's root broker [?]
To retrieve the root hash of the management server authentication broker, run the following command:
\program files\veritas\security\authentication\bin\vssat
showbrokerhash
/opt/VRTSat/bin/vssat
showbrokerhash
The output of this command looks similar to the following:
Root Hash: 9dfde3d9aaebee084f8e35819c1fed7e6b01d2ae
Enter the alphanumeric string (the string you receive is different from the one shown).
y
to verify that the information up to this point is correct.
y
to start Veritas Cluster Management Console processes now.
Do you want to start Veritas Cluster Management Console processes now? [y,n,q] (y)The setup program presents startup progress percentages and, if successful, displays the following message:
Installation completed successfully on all systems
After the console starts, the setup program displays the location of the upgrade log files and then displays:
The setup program eventually displays the following message: