Upgrading DMP
Prev Performing the product upgrade Next

Upgrading DMP

This section describes the tasks to be performed while upgrading DMP.

Supported upgrade path: DMP to InfoScale Foundation

Note:

After the upgrade is complete, the installer wizard performs certain cleanup tasks and a command prompt is displayed for certain time. Ignore the prompt and continue with the further tasks. The command prompt closes after the cleanup tasks are complete. Do not close the command prompt before the cleanup tasks are complete. The cleanup tasks are aborted if you close the prompt.

The following figure lists the tasks to be performed to upgrade DMP, where replication is not configured.

Figure: DMP upgrade tasks

DMP upgrade tasks
References:

Task

References

1

See Preparing the systems for an upgrade.

2

See Installing the server components using the installation wizard.

See Installing the server components using the command-line installer.

3

See Deployment scenarios and applicable post upgrade tasks.
Prev Up Next
Re-enabling Volume Replicator in a VCS cluster Home About transitioning between the InfoScale products