This section describes the tasks to be performed when upgrading SFW.
Table: SFW upgrade tasks in a non-clustered environment lists the tasks to be performed for upgrading SFW in a non-clustered environment
Table: SFW upgrade tasks in a non-clustered environment
Step |
Tasks |
||
---|---|---|---|
1 |
Review the pre-upgrade tasks to be performed |
||
2 |
Review the upgrade notes |
||
3 |
If your configuration has DMP configured, then it is recommended to reduce the number of paths to each array to one, before you begin the upgrade. For more information about the hardware and software prerequisites for DMP DSM installation, refer to Symantec Dynamic Multi-Pathing for Windows Installation and Upgrade Guide. If you do not have DMP DSMs in your existing environment, but plan to add this feature during the upgrade, add the HBA(host bus adapter) hardware before performing the upgrade. Connect no more than one path from the new HBA to the storage array before the upgrade and DMP DSMs installation. Select the DMP DSM option or the appropriate DMP DSMs while running the installer. |
||
4 |
Perform the upgrade steps
In case of Volume Replicator environment, first perform the upgrade on the secondary site. No preparations are required on the secondary site. See Installing the SFW or SFW HA client components using the product installer. See Performing an automated installation for SFW or SFW HA server or client components. See Installing the SFW or SFW HA server components using the product installer. |
||
5 |
In case of Volume Replicator environment, prepare the existing primary site for upgrade See Preparing the primary site for upgrade in a non-clustered SFW environment. |
||
6 |
Upgrade the nodes on the primary site |
||
7 |
Move the applications back to the original primary site |
||
8 |
Perform the post-upgrade tasks |